Wire beak holder by benspawn

Last crawled date: 3 years, 5 months ago

Beak for wire holding.

I remixed this wire beak (original beak design by charlesmouse for his Wire Bird) to go with Cybertron3D's third hand solder helper. 8.25mm sphere and fits directly into the female cup. I remixed it because I found it was impossible to print the original version without any supports. You print this standing up. Print slowly to get the first layer adhesion as it's a small area. I had my first layer printing at 5mm/s because it's PETG and the filament is sticky and tends to want to pull. You can probably print this faster in PLA.
It's not meant to replace the crocodile clips but in COVID-19 times, you might need something printed to use immediately instead of waiting for an order to arrive.

Thanks for looking and using this!
If you like my design, and are feeling generous, feel free to leave me a tip!
Check my page out often for more designs as I continue to create and design stuffs!
Happy 3D-ing!