Yawvr center mount adjustable locking mechanism by VirtualmisterL

Last crawled date: 3 years ago

This is a multi position adjuster for the center stand wheel/yoke holder on the yawvr motion simulator.
It will lock the stand in position stopping it from hinging back & forth making it much more solid than the default solution which has a tenancy to move while in use.
You will also need to purchase an indexing plunger with m10 × 1.5mm thread (specifications are in a photo) & 2 x nuts & bolts to fit the curved piece to the bottom of the yawvr center mount.
It is designed to align with existing holes & fit into the gap between the 2 curved support pieces in the front section height adjuster.
The thread for the m10 indexing plunger was designed to be tight, so make sure to clean the support material in the thread out well & be prepared to use a spanner to screw the plunger in.
Once its been screwed & unscrewed it should loosen.
The indexing plunger can be used in either left or right side & the whole piece can be orientated so the plunger is in the inside or outside of the frame to suit preference.
I also included in the design a 3.25mm washer for my index plunger to screw in the perfect distance.
You might not need or want this depending on the length of thread on your index plunger.
You will need to Print 2 of the screws.
IMPORTANT
This will likely only work with the earlier yawvr units ie.. kickstarter & early purchases, as it seems they changed the design of the front height adjuster on the center holder.
If you have a version made from one piece with bends, then this version doesn't look to be connected together with round bar so will not be compatible.
Please compare yours to the pictures
If you like this design then please give it a like or even post a make
Any problems or feedback, leave a comment
Enjoy!