UPDATED!!!! Follow Focus + Lens Holder Kit for 8mm rods (rail setup) 48mm wide by amats

Last crawled date: 3 years ago

UPDATED!!!!!
The rail base to be adapted on the "BeastGrip's Remix" edition has been added. The width is the maximum possible and was designed on the dimensions of my fablet 5.5''.
Also a tripod's mount with an M6 screw to adapt on it, has been replicated!!!
!!!!WARNING!!!!
It is not tested yet... waiting for a couple of rings to have the lenses mounted properly.. !!!! Lenses and DOF weight on the photo are hold totally from the holder... which makes it quite strong :)))
Not much to say, it is a tiny setup for light cameras with 8mm 48mm spaced rods/rails, personally i designed it for BeastGrip's hack edition. The lense's gear is specifically designed and fits like a glove on Helios 44-M lens. The holding ring for the lens has a 63mm diameter (was designed actually for a DOF adapter).
You 'll need beside the prints :
2 x 8mm rails (mine are from aluminum)
7 x 10mm M3 screws
1 x 24mm M3 screw
1 x 20mm M2 screw
3 x Bearings 3mm ID - 10mm OD
7 x thin washes (as spacers 1 x inner, 1x outter per bearing, 1 x knob side)
9 x M3 nuts
The setup is quite explainatory, the 2 photos gives you the idea what goes where, but for any questions i'll be willing to answer. On the two bevel gears both screws end on a nut.. tighten them enought to have a smooth motion on the gears... and put a drop of super glue on the nut and screw connection!!! It worked out fine for me!!!