Tobacco carrying case

Last crawled date: 4 years, 3 months ago

~ Remix of Galansky's model to fix some tolerances ~
Carry your tobacco, filters and papers in one neat box. Say goodbye to messy plastic bags or expensive to replace holders. Rolling papers will fit tightly when full and remain in place even when you have a few left.
Printing tips:
Print using two walls and tree supports for the back. I suggest using 0% infill, as the model doesn't need the extra support (trust me, I tried breaking it). Brim is highly suggested but not necessary.
Post processing tips:
After printing you MUST clean the grooves in the door sliders. I use a box knife going from the inside to the outside, pulling loose filament and cutting top and bottom of the groove until the knife glides with ease. Corners will be a PITA, but with a scalpel you should have no problems. Remember to clean and square off the doors, as plastic can expand, so a little sanding/cutting might be necessary, depending on your printer.