Dual Z Braces with Dual Z Rod Bearing support and Filament Guide for Ender 3v2 by Sympotonic

Last crawled date: 3 years ago

If you can use the print, please feel free to add a tip
I spent tons of hours and material to get it right in the sweet spot =) I will appreciate it.
This is a remix, with all top brackets included. Its a dual Z brace support system, with integrated bearing guide for dual Z rod, and a filament guide on top with bearing wheel at the left side. Works with single and dual z rod setup, with or without motor, and with or without bearing wheels at the top (print socket is enough to make it steady, however it will give you a little moving area.
Sources:https://www.thingiverse.com/thing:3719799https://www.thingiverse.com/thing:4668292https://www.thingiverse.com/thing:3085765
Every print parts for the setups is included. Even the filament guide and bearing wheel at top, and the small filament guide, there fit directly onto the z rod mount at the stepper motor.
To Complete the installation you need:
1m x M10 threaded rod (cut in half. mine is 475mm each)
4 pcs × M10 nut
4 pcs × M10 acorn nut
8 pcs × M10 washer
14 pcs × M5 T-nut
14 pcs x M5 10 or 12mm bolts
1 pcs x 625zz bearing for the filament guide wheel
2 pcs x 608zz bearing for the z rod support (1 is enough, if you dont run dual z rod system)