Anycubic Predator Duet2 Wifi Mount by SkymasterCR

Last crawled date: 3 years, 1 month ago

This started out as a remix of Rizza81's (https://www.thingiverse.com/thing:3565289) mounting plate.
My version was made much thicker, with a greater offset for the MB for cooling. This bracket is semi-adjustable, and I added an opening on the exterior that allows exterior access to the SD card and USB port while also protecting the WiFi antenna.
Here's an installation sequence. Mount the plate loosely by itself in the empty case(without motherboard) with the side plate still on. Slide the bracket against the exterior plate, then mark the size and opening of where you need to cut the exterior opening (in the side panel). Once you know the opening location, remove the side panel and cut (in my case w/Dremel sanding wheel), then reinstall it. If the cut is a bit rough, that's OK. Remount the plate and slide it against the opening...and then place the snap-in cover on the exterior to give it a seamless look. Then tighten down the necessary screws.
The plate vents pretty good, in my case just perpendicular to the side panel, crossing over the motherboard.