Z Endstop Extension, Printrbot Simple by iamjonlawrence

Last crawled date: 3 years ago

Is your Printrbot Simple Z end stop adjustment screw just a little too short?

Did you know by turning the Z end stop adjustment screw 45 degrees your height will change by 0.1mm?
This thing will thread onto the end of your Z end stop adjustment screw to give you 10mm more length. Also, every 45 degrees there is a mark to indicate a change of 0.1mm in height so you can more easily see how much you are adjusting.
2014-02-17, RevA: Reduced diameter to help clear XL versions, and reduced contact surface where it engages the switch. The large flat bottom of the original design is not forgiving if installed slightly crooked. Rev. A is more forgiving with it's smaller contact area, and adds 5mm more to the overall height.