xyz 30 40 60 mm test cube cr-10 comparison & jerk acceleration test by wayneuk

Last crawled date: 3 years ago

fed up printing cubes & forgetting what was what..
dont forget u can also make them bigger in the slicer
make sure its the correct way on your bed
printed on the cr -10 with micro micro swiss 300 hot end
standard cura profiles "cura 3.04" for them speeds 30-40-60
things ajusted
retraction to 2mm the micro swiss dont like much or seem to need it
pla
temp 215
.2mm layer
10% infill
z seam at random
everything else is standard profile
The last pics in white 30mm i have altered the jerk & acceleration settings in cura
now no lines its super smooth no ringing or banding or little bits on the super sharp corners
"Frigging Perfect"
jerk from 20 to 8
print acceleration 800 from 500 seemed better
adjusted in cura 3.04
i have tried as low as 400 with better results but longer print times
if you have a cr 10 please post your makes as i should of done this before swapping the hot end for a real side by side look at them