xxs delta by Hatsyflatsy

Last crawled date: 3 years, 1 month ago

After building some large delta's it's time to make things smaller
I remixed some parts from this nice design, the Sculptr Delta MK1 by 3dprintingtips (https://www.thingiverse.com/thing:1444028).
Fully printable on a 22mm bed.
Has no heated bed and runs on a MKS MINI board.
The print bed is a makeup mirror with a 8cm diameter (Don't tell my wife).
Printing size approx 80mm in diameter and 126mm z highed
------------------------------------------------------UPDATE-------------------------------------------------
I uploaded a different version of the effector V2 the original uploaded file does not work properly.
Ino has also been uploaded. (arduino 1.6.1)
Some specs
Diagonal rod lenght 82// mm
Smooth rod offset 83.0// mm
Effector offset 22.0/ mm (uploaded config_h state's 20, please change)
Carriage offset 20.0 // mm
Maximal print high is aproxaly 126.0//mm
Pully teeth for the beld is 16 GT2
Timing belt GT2
Extruder is a mk8 full metal
Stepper motor 42mmx42mm
Rod ends are traxxas. The rods themself are made of 4mm threaded bar.
Bearings used for the carriage:
Bearing type: LM8UU
Length: 24 mm
Inner diameter: 8 mm
Outer diameter: 15 mm
Clips for the LM8UU bearings
Diameter: 15 mm
Material: Steel
Thick: 1 mm
Vertical rods for the LM8UU bearings are in this build 8mm steel rods and 300mm in length. So i could make 3 out of a 1000mm rod. Yep i'm Dutch :)
The aluminium stabilizer rods are 330mm of length.
Hotend is a stock E3D v6 lite
Current setup has no second fan to cool the layer (yet).
I uploaded the second fan holder. This one can be used as a add on for the fan duct that's included by the E3D v6 lite. The layer cooling fan is controlled by the MKS MINI. So you have to make a direct 12v connection for the hot end. This ensures that you always have this fan running.
Motherboard a MKS mini V1.2, this one has no option for a heated bed.
If you want this option, you have to add a mos module.