WW1 fighter planes for microarmor by Captain_Ahab_62

Last crawled date: 3 years, 5 months ago

series of WW1 planes for microarmor
they seem to print very nice with resin printers
( danke schoen dt118 ! )
for FDM, just try to orient the model so the struts are at a 45 degree angle to avoid supports on them
I'm just tossing these up as I do them
model in full dimensions in blender 2.82 and exported from blender 2.79b* at 1/100 for the .stl file
scale down to 35% in the slicer.
I've had issues exporting .stl's from 2.82 for Cura; 2.79b and 2.80 export the same mesh to different file sizes, too. So I export the mesh from 2.79b for consistency's sake.
no test print because I'm very lazy and these are very difficult to clean up with damage
( struts are often only .5mm thick )
I'll probably print these at 1/200 scale
Albatros D.2 w/ side radiators
Albatros D.2 w/ wing radiator
Albatros D.3 ( D.5 & D.5a has a slightly different fuselage, but likely not noticeable at these sizes )
Sopwith Tripe
Sopwith Pup
Sopwith Dolphin
Sopwith Camel
Fokker D.6
Fokker E.5 ( D8 )
Fokker Dr.1
Fokker D.7
SE5a
Nieuport_17
Nieuport_28
Pfalz D.III
Pfalz D.IIIa
Halberstadt D.II
Airco DH-2
SPAD 13