WPL C14 Side Fuel Tank for Li-Ion 18650 by edwardchew

Last crawled date: 3 years, 1 month ago

Well so the WPL 1/16 C14 is considered a rock crawler, considering the low speed and grippy tires of the kit. But the CG is too high.
The reason i made this is to make a lookalike fuel tank that houses 2x 18650 Li-ion inside, and where it mounted, is at the center of the chassis and much lower CG than the stock location, reducing tip over at steep climb angle
Print settings
a. Side fuel tank V2 - print at 0.3mm, upright for best finishing, with brim and support
b. Clamp 1 & 2 - print at 0.1mm, brim is a must
c. Cover + & - V3 - try print at 0.1mm, with the symbol facing up
Assembly
Drill the fuel tank mounting point with 2.5mm drill bit, then screw it onto chassis with M3 screw, glue the Clamp onto the tube. Once you have wired up the 2 Li-Ion, cover it up with the Cover + & - file
Get WPL C-14 Truck herehttps://www.banggood.com/WPL-C14-116-2_4G-4WD-Off-Road-RC-Military-Car-Rock-Crawler-Truck-With-Front-LED-RTR-Toys-p-1251046.html?p=DG23031123036201501P
Get genuine Panasonic NCR18650B herehttps://www.banggood.com/4pcs-NCR18650B-3400mAH-3_7-V-Unprotected-Rechargeable-Lithium-Battery-p-943453.html?p=DG23031123036201501P
3D Printer i usedhttps://www.banggood.com/DIY-Creality-CR-10-3D-Printer-300300400mm-Printing-Size-1_75mm-0_4mm-Nozzle-p-1085645.html?p=DG23031123036201501P