Wowstick 1F+ Flat case by kitlaan

Last crawled date: 2 years, 10 months ago

A Wowstick 1F+ holder, with space for 40 bits.
(A bit wider than the original case, but also flatter and less-long.)
Uses four 4x2mm disc magnets to hold the halves together.
Printed with 0.2 layer height.
Screwdriver fit is proper, though test with was with an earlier iteration.
Hexbits fit is a little tight, but loosens with a few insertions.
Will update this from WIP to real (with pictures) once I'm done tinkering:
Do fingers fit to pull bits out? (Need to lengthen the case?
Magnet fit and strength? (Need stronger/bigger magnets?)
Screwdriver fit w/ halves? (Increase height tolerance?)
Print-in-Place Hinge? (How annoying are bits?)