Working Trigger/Hammer/Bolt for DL-44 by Dpmohney

Last crawled date: 3 years, 1 month ago

These are also remixes from jonnieZG mods
These mods add trigger, hammer, and bolt functionality, as well as the ability to disassemble the blaster as needed.https://www.youtube.com/watch?v=3AlSItja6sI
01_Barrel - Added hole for bolt spring screw (M3x18mm)
02_Bolt - Added chamber for spring (Compression spring 1 7/8" L x 5/16" OD x .026 WG)
11_GripPin - Modified length to correct length
15_TriggerMechanismA - Narrowed part to facilitate barrel sliding over it to lock it down
16_TriggerMechanismB - Narrowed part to facilitate barrel sliding over it to lock it down
19_CrossbarSpacer - Enlarged hold to accommodate Thumbnut screws (8-32x3/4")
33_HammerMechanism - Instead of cutout for nut, made small hole to allow thumbnut screw to hold this piece in place, thus allowing for removal if needed.
34_Crossbar - Enlarged nut opening for 8-32 nut
35_ThumbnutA&B - Enlarged hole for 8-32 bolt
36_TumbnutMiddleC - Enlarged hole for 8-32 bolt
Hardware list:
Flashhider Setscrew (Sockethead M4 x 16mm)
Bolt Spring (Compression spring 1 7/8" L x 5/16" OD x .026 WG)
Thumbscrew Bolts (8-32 x 3/4" (x3))
Thumbscrew nuts (8-32 (x3))
HammerSpring (15/16" L x 5/32" OD x .016 WG (trimmed to 5mm))
HammerSpring Screws (#2 x 1/4" Steel wood Screws (x2))
Hammer Pin (Roll Pin M4 x 16mm)
Trigger Spring (7/8" L x 9/32" OD x .15WG)
MagazineFloorplate screw (6-32 x 1/4 ")
Bolt Spring Screw (M3 x 18mm)
I will add pics in the comments for assembly assistance.