WIMUv3 hinged square bar holder by M_G

Last crawled date: 3 years ago

Parametric hinged and bolted attachment for square bars
This OpenSCAD script will generate a 2 part holder to attach a Tyndall WIMUv3 to the upright square cross-sectional posts on the moveable sled part of the assassin trainer at Bath University. The size of the bar it is attached to can be parametrically varied
Version: 0.9
Date: 2012-05-31
Todo:
clean up code to make more parametric
test fit and adjust
add "wiggle" for bolts and captured nuts
add option to choose orientation of WIMU holder section
add optional corner fins to prevent thermal stress cracks when printing in black ABS
Warnings:
None
Note:
You will need to also have the modules mouse_ears_test.scad, pivot_1_0.scad and rounded_cuboid_v2.4.scad in the same directory or your library for this to compile correctly
Changes from previous versions:
0.9
added option to choose position of hinge/bolt holes along sides
added second captive nut section on side for tightening holder to bar
0.8
added tolerancing for bar fit
added second bolt pivot
0.7
added padding partial cutout between Z axis of wimu and front/top face of wimu holder
added variable for and increased pivot size around hinge pin to 5
added extra mouse ears under wimu holder in attempt to prvent it from curling etc.
increased height of wimu by 0.8 mm as previously printed item despite having a nominal .stl measured height of 31.4 it measured only 30.2 when printed also note average height of 5 wimus measured was 31mm
0.6
increased size of side holes to allow for viewing of status LEDs
changed the size of cutouts on WIMU holder section to help with removal of WIMU
added cutout under WIMU holder to help with removal of WIMU
added captive nut section for tightening holder to bar
0.5
added WIMU packaging to check location of cutouts
0.4
Adjusted position of cutouts around hinge and bolt clamp so that they dont go all the way through the wall to make for easier printing and drilling
Made hinge pin larger to make it easier to insert hinge pin without drilling
0.3
Added option to add device holder on side or not using use_holder variable
Fixed large clamp part so that it has correct internal dimensions
Increased height of small cutouts on long side of WIMU hodler so that activity LED can be seen
added comments
Moved everything up onto the build plane
Fixed some translate issues where bar_stock_l and bar_stock_b were mixed up
Moved the hinge and bolt side cutouts so that a thin piece of material would connect the 2 halves
Moved the mouse ears into the union and differecne operations applied to the main clamp body
0.2
reduced individual parts count by using the pivot module only twice and using cut lines to split it up
0.1
First attempt