Wall Lamp by joov

Last crawled date: 4 years, 1 month ago

This is a wall mounted lamp for LED bulbs only.
You have to buy a lamp socket for E27 (max 7 W) bulbs as shown in the pictures. In addition you need wires to connect to a wall outlet.
Print upper and lower lampshade with
white PLA
0.2mm Quality
100% infill
5% support
brim
Remove support of upper and lower lampshade with care as to keep the three "foots" intact
Print ring with
0.2mm Quality
20% infill
5% support
no plate adhesion
Remove support of
lower wells (3)
lower foot holes (3)
wall mount cavity on backside of wall plate
screw-holes in wall plate
inner hole of ring leading from wall plate to inside of ring
DANGER: Do not do any electrical wiring if you have no sufficient experience!
To connect the lamp to the wall outlet have to pull the wires through the hole in the wall plate to the inner side of the ring as shown in the picture
Assemble the lamp by inserting upper lampshade with 3 foots of the upper shade going through the 3 holes of the ring, Check that the lampshade is fittet into the well of the lamp ring, then turn right.
Do the same with the lower lampshade