VORON 1.0 - LM10 Bearing Upgrades by themakeproject

Last crawled date: 3 years ago

VORON CoreXY 3D Printer (10mm Variant)
Based on Design: https://github.com/mzbotreprap/VORON
Reddit: https://www.reddit.com/r/voroncorexy/
Updated STLs to use 10mm shafts and LM10LUU bearings (and some IGUS bearing alternatives)
NOTE: I will be adding more files as I work through my designs and confirm and do final tweaks, starting with Z axis.
Z Axis
Upper Support x 4
Lower Support x 4
Bed Support Carriage A x 2
Bed Support Carriage B x 2
Print the included Z Axis parts as well as the standard center bed support coupler and standard stepper mount.
These parts will be a drop in replacement using 10mm shaft and LM10LUU long bearings (you could also use short but long will prevent racking)
XY Axis
Left Bracket x 2
Right Bracket x 2
Main Body x 2
The XY is a completely upgraded joint and has been upgraded to fit the LM10LUU long bearing and 10mm X shafts.
NOTE: There is now an alternative pair of Y-axis brackets that supports the 12mm OD and 10mm ID IGUS bearings, not yet tested, currently printing. These are the same bearings as used on the Tech2C HyperCube
Y Axis
A Stepper Mount x 1
B Stepper Mount x 1
Idler Bottom Bracket A x 1
Idler Bottom Bracket B x 1
Idler Bottom Rod Holder x 2
Use the standard Idler top mount from the VORON files
X Axis
Recommend using the standard VORON X carriage, run 1012 IGUS bearings and print an adapter to insert them into to fit the LM8UU bearing size on the carriage. This will keep it compatible with future and V1.5 updates.