Violin v2 Top and Side Additions by TORCH

Last crawled date: 3 years, 1 month ago

I rendered these files in Tinkercad to add to the Violin V2 project just for more aggressive look. Fixing them was done just by adding metal (you can use plastic) dowel pins placed into frame of the violin. All were then fixed with a hot glue gun.
Mirror your prints. The top additions can be printed at the same time on a 220x220x230mm 3D printer. The knife sides on the bottom will likely need to be printed separately.
NOTE: Take note of the placement of dowel pins, if using them. On the top of the violin, you don't want to block the string holes. On the bottom sides, don't go too deep as to make assembly of the Peizo pickup setup hard to install.