VA INNOV-entry 01-POWER GRIP

Last crawled date: 1 year, 11 months ago

Power Grip, masculine in design, for people who always in the workshop.

-The design basically based on a hand,
* it has a wrist , where it can move sideways, up & down
* it has fingers, made from a 2mm thk plate shaped as shown
-The grip has two variations
* First is the rubber grip, movable and has ridge perpendicular to its body to have a maximum grip. effective for metal or smooth materials.
*Second is the spike like grip on the edge, inward just at the top of the rubber grip. this will insure a double grip effectively on wood or plastics materials in where it can sink its spikes on.

-The way you can use this is to tighten the 10mmØ screw with a knob, turn it clockwise and it will close, pushing lower jaw inside, making it close. do it the other way (CC) making the nut closer to its endpoint making the jaw open.

-The vertical angle it can rotate is 30 degree
-The horizontal angle is 40 degrees

-The idea of the wrist design, is to effectively used the hammer, a mallet or a manual saw or anything you can grip on freely as using your own hand. (this just my idea, it s prototype and not tested).

Hope you like it.