USB and Pencil Holder - Breast Cancer Foundation

Last crawled date: 4 years, 3 months ago

Breast Cancer Foundation Cube
CUBE: Infill 20%
In CURA select Experimental - Tree Support with infill 30% for the trees support
Breast Cancer Foundation SEAL: (Option 1, Simple Color Layers)
Background White: 0 to 1.0 mm
Silver: 1.0 to 1.6 mm
Pink: 1.6 to 3.4 mm
Silver: 3.4 to 4.0 mm
As you can see in the pictures, I did a lot of work on Cura to create separate G-codes for each component and at the end I was able to print the outer ring in silver without crashing with the parts previously printed in my Ender 3.
You can use the included G-codes to print in an Ender 3 (option 2 below)
Breast Cancer Foundation SEAL: (Option 2, Mixed Color Layers)
1 - Background White: 0 to 1.0 mm
2 - Silver: 1.0 to 1.6 mm
3 - Pink: 1.6 to 3.4 mm
4 - Silver: 1.0 to 4.0 mm
If you have an Ender 3 you can use the 4 G-codes to print the Option 2 of the Seal.
Please note that the G-codes 1 thru 3 do not turn off the bed at the end of the print, this is to prevent the print to cool off and loose bed adhesion.
It will take about 20 minutes for the first print, and less than 10 minutes for prints 2 and 3.
And about 20 minutes for print 4.
The dimensions are set to press fit the seal into the cube
Be careful with the alignment before pressing it
once in place it will not come out in one piece
Please send a message or post a comment on how was your experience with the print.
Hope you like it.