ULTIMATE triple drawer for Ender 3 PRO - Easy mount

Last crawled date: 4 years, 2 months ago

This project is intended ONLY FOR ENDER 3 PRO.
Please support my work at:https://www.paypal.me/SalvoOgnibene
Also 1$ or 50c are welcomes.
This is a ultimate triple drawer box for Creality Ender 3 PRO. It doesn't need to remove Y-axis, avoiding to calibrate belts tension again.
I got tired of all versions and remixes... I DON'T WANNA remove the Y-AXIS on my printer, so I decided to start from scratches.
The box will stand in position thanks to a T-nut (included) on the left side. It's a little hard to make in position but it's the best solution. The rear T-nut is not required. Mount it only if you want (I don't recommend, just ignore).
Print the T-nut a 0,2 resolution and at least 10 walls with lowest speed without supports.
This project is compatible with the cable clip (included) to retain the display cable between X-axis and drawer box.
Print the cable clips at 0,2 or 0,4 resolution without supports.
There are two boxes: first one is a normally box, second one is a "light weight" with many diamond windows to save filament. This light box needs a little post processing at the bottom of each diamond.
Print the box at 0,2 or 0,4 resolution, NO SUPPORTS needs, print in vertical mode.
The first drawer have a space to save original Ender pliers. :)
Print the drawers at 0,2 resolution, NO SUPPORTS needs.
Print in orizzontal mode. If you've "warping" results, use a brim support.
Each drawer has many under-drawer (bowls) inside for easy bring.
Print the bowls at 0,2 resolution, NO SUPPORTS needs.
Cut any seam signs on them to avoid jams.
Beware: use a well calibrated printer because the joints are very tight. The left joint normally doesn't need any post processing and it's normal if you can fit the first time. Let's slide 10-15 times to take the shape.
I've not an Ender 3 (non PRO) and I cannot design a short box for it.
If this design will have has succes I'll try a Ender 3 version and a lot of other large and short drawer.
Don't forget to post your make!
Please, support me with a tip at:https://www.paypal.me/SalvoOgnibene
Thanks.