Ultimaker 1 E3D v6 Bowden mount by Dr-Idee

Last crawled date: 3 years ago

E3D-V6 mount for the Ultimaker 1
--
is remixed from Musti's E3D mount.(http://www.thingiverse.com/thing:145988)
The interior, which holds the E3D (E3D-v6) all metal heatsink bowden edition, is redesigned for the v6 version.
Just order from E3D online:
v6 Heatsink 3mm bowden
v6 heat sink break 3mm
30x30x10mm DC fan
Then print the parts and you are good to go. I used the original UM1 heater block, extruder nozzle and thermocouple and printed these parts in ABS.
Also printed the fan-duct from Musti, which I had to remix slightly post print using a set of pliers to cut away some plastic so the original UM1 heater block does't touch the fan duct. (Too impatient to redesign the fan-duct for this setup :-))
If you need it and are not in the position to print, you can find it online at our website! (Dutch, willing to ship outside NL)
............
Update:
............
Although my version 2 was working great, I am working on a version 3, which has:
the top of the E3D-V6 better aligned to improve the bowden clip mounting
enable slightly better cooling of the E3D-V6 heatsink
an additional mounting area at the bottom for the original thermo couple amplifier PCB so your build plate is beautifully lightened by the blue led from the amplifier.