Tube grinding jig by ps_bond

Last crawled date: 3 years ago

Yes, yes - I know. A plastic tube grinding jig?
This is for holding thin-wall tubes at 90 degrees to the grinding belt on my KMG to trim them square, then use the 45 degree V to deburr them. I've no intention of doing heavy grinding with it, it won't handle the heat. Ridges on the underside to reduce friction for side-to-side passes; my table is roughly 100mm deep, so there's an allowance to keep it clear of the belt.
ABS or ASA are slightly more tolerant than PLA, so I'd recommend those if possible.