Travel Pegs & Jokers by jimdod

Last crawled date: 3 years ago

I created this to be a travel version of Pegs & Jokers that would be lightweight, as well as fit on a smaller table. There is not a "standard Pegs & jokers" and this version and ruleset we call the California rules (Rules are included in pdf file).
This set uses standard ~1/8 inch (~3.2mm) cribbage pegs that can be found on ebay and other sites.
I show a picture of two configurations, a eight player setup with a four player setup inside. Also a ruler so you can see the size. Four and six players are common.
I designed this to print diagonal on a 120mm x 120mm print bed.
I included the latest version of the scad code. Warning this code is a little rough and can be a bear to modify. This was my sixth generation of this game.
30-AUG-2018 update. changed the overlap joint to a dovetail that works much better
12-SEPT-2018 update. added recesses for non-slip bumpers, other slight improvements.
30-JUNE-2019 update now can print board side as a single piece, a larger bed is required about 200x200