TP-Link SG 108 under desk mount by csmart30

Last crawled date: 3 years, 1 month ago

Remix of https://www.thingiverse.com/thing:3089825 removing the bottom ethernet/cable holders for a very slim mount. Snaps into the 2 mounting holes on bottom to hold it in place from moving back and forth when mounted under a desk, so only 1 is needed. Goes right at the edge of the desk, otherwise getting the ethernet plugs out would be difficult due to the tabs facing up. On the flip side would make it so it would be more difficult to have someone else unplug your stuff. May Make another version that can be bottom facing in the future.
I wanted the mount slim enough that it can still function as a desktop switch with the rubber feet included with the switch and not get in the way.
Printed in PLA with 5 wall count, so its equal to 100% infill but goes quicker because its all straight continuous lines, takes about 50 minutes at 60mm/s. Printed without support so needed to trim a small part of overhang for the 2 studs but still snaps in place nicely.
UPDATE: created V2 for those that want to flip the switch over to more easily remove the ethernet plugs, as before leave on your rubber feet that came with the switch. Prints in 2 parts