Tinywhoop Canopy Collection by DanTheBarbarian

Last crawled date: 4 years ago

Three canopy dies for vacuum forming, one of which was designed specifically for the shortest FX965TW Pinch camera mounts by Tinywhoop.
The Stoop Canopy: About 16mm tall, designed for the Pinch camera on the shortest mounts. Accommodates 5 -25 degrees of tilt.
The Swoop Canopy: About 18mm tall, designed for the FX 900/950 series, but fits similarly sized setups as well with tilts between 5 and 25 degrees.
The Sloop Canopy: About 20mm tall, meant for 14mm cameras on somewhat higher mounts and thicker 14mm cameras, like the Caddx Firefly on a lower profile mount. Also handles 5 to 25 degrees of tilt.
There is not much difference in weight between the three models. Even the largest of the three, the Sloop, is only a little bigger than Tinywhoop's Mech canopy. HDPE has been the best material to form them from, but PETG and HIPS have done fine as well. One item of note concerning the camera hole; cut around the outside using the 'plug' as your guide rather than the inside, otherwise you will find the opening too small. These designs are not meant to clip onto frame pegs, but to be screwed down on top of the FC.