Tiny Whoop Arrow Frame by techyg

Last crawled date: 3 years ago

This is a frame that can be used as a replacement for the stock Inductrix v1, aka Tiny Whoop.
This is my first frame design- I came up with this after 5 different revisions. I tested it (as pictured) with an Inductrix v1 board. I wanted to design something that would serve as a good replacement, have decent flight time, hold up to crashes, and also be easy to print. If you get this working with another board, please let me know and I'll add it here. I plan on making revisions to this- if you have any helpful feedback let me know also.
On my printer, this takes about 35 minutes to print. The frame itself is less than 6g, and with all the components (board, camera, camera mount, battery, screws, motors, etc.) it weighs 26g. No supports, rafts, etc. are needed and I used a 20% infill.
I recommend using ABS, as PLA is too brittle and will break after a few crashes.
Please note that there is an orientation for this frame. Refer to the picture. The board will also only fit one way, due to how the motor connectors are set up.