Thrustmaster Cougar MFD CLAA070MA0ACW Housing (With internal controller board and added buttons) by Bigyin13

Last crawled date: 3 years ago

This is an upgrade to the original TriggerBMS housing design but with added internal controller board and buttons added to the case.
I create this after a crash course in TinkerCAD so these files while having some artifacts and a little sloppy internally, are completely functional and are completely clean looking externally.
Images of parts were printed with larger 0.6mm nozzle, layer height and higher speed for a quick proto print and so are not representative of the much cleaner print possible with a smaller nozzle and better print settings.
Below are TriggerBMS original instructions with added steps for the addition of buttons.
This is specifically for the 7" HDMI Screen Raspberry Pi Display CLAA070MA0ACW 800x600 LCD Panel and the Thrustmaster Cougar MFD frame set!!!
Hardware required:
The CLAA070MA0ACW Panel set

Thrustmaster Cougar MFD set

2-4 M2x4 screws

4 M4x6 screws

3-4 M3X6 screws

3 M3X12 screws

2-4 M3x16 screws

3 M3 press nuts

2 M4 press nuts

4 M4 screws (Length determined by application of VESA Mounting)

Washers/spacers for M4 screws (VESA Mounting)

Double sided Tape

Hot glue gun