TheMiniFPVSpiderQuad v1.5 by ardujustin

Last crawled date: 3 years ago

TheMiniFPVSpiderQuad, built from the electronics found on the Syma X1 mini quad. Has under-slung battery bay capable of holding 1s 350mah to 1s 850mah batteries. Rear battery bay is designed for the 808 key-fob lipo. All up weight with stock battery: 83 grams.
WARNING! This is an experimental design. The Syma X1 flight controller is programmed for traditional X quads. A spider design, while not beyond it's limitations, will still produce what some might call "squirrely" flight behavior. Proper adjustment of transmitter throws can overcome much of this. You have been warned!
Parts List:
4x Syma X1Motor/Arm combination
1x SYMA-X1-R-V5 flight controller
1x TX5823 200mW 5.8 ghz video transmitter
1x 808 #16 key-fob camera
1x FlySky/Turnigy/Eurgle 9x RC transmitter (this cheap transmitter can bind to the Syma X1 flight controller, it permits longer range and ability to adjust throws, which is necessary for an enjoyable flight)
Model Orientation: The uploaded models orientation is untested on the print bed. For best results and strength, it should be rotated 90 degrees either direction so flat sides are horizontal to your print plate.
Material: ABS
Amount Used: 15.3 grams
Model Weight: 10.8 grams
Resolution .20mm
Print Time: 1H 51M
Part wall thickness 3 layers
Supporting raft: 2 layers
Support density: 2 layers ( try to go as thin as you dare, weeding the part can be a delicate process, made much easier by thin support structures)