Tevo Tornado Z brace

Last crawled date: 4 years, 2 months ago

I wanted a brace that wasn't made with a bunch of parts.
Considering torque and torsion, I decided a rigid brace would be fine.
So far, I haven't had any problems.
All you will need is two (2) pieces of 1/2 inch (12.7 mm) metal tube with your print.
I used EMT conduit. Available at any home improvement store.
Cut the tube to a length of 23 3/4 inches (60.325 cm).
Put one of each post in the ends.
Remove the outer screw from the bottom corner.
Slide it into the extruded rails.
Return the screw to its hole.