Tevo Tarantula Electronics Enclosure .case by Aynareth

Last crawled date: 3 years, 1 month ago

This is case.
It is made for the Tevo Tarantula Board and 2 Mosfet.
It can be printed on the small Buildplate (200x200mm), so everyone can print and use it.
For the cooling fan there are three Options ranging from 40 to 80mm.
I know the Design can be al little cramped with all the Cables, but everything fits!
The Design is well tested and working. If you have any Problems getting all your cables through the Holes, you can cut out the middle parts, to get a bigger hole.
With the Mounting Holes on the Back, and the Side, you should have enough Options to mount your case to the Frame. There are Offset Brackets included as well.
What you need:
12x Motherboard Screws 9x5mm (4 for MKS Board and Mosfets each)
4x M4x6 for the Cover
4x Screws for the Fan, depending on your Fan Size.
You can use Brass Inserts If you like.
A 4mm Drill because the Screws are a tight fit!
Update 02/23/2018
Added a 70mm Fan Cover
Update 01/06/2018
Added a 92mm Fan Cover
Update 10/16/2017
Uploaded a new STL File for the Main Body due to a 1 degree tilt in the old file. Should be fixed now.
Update 09/04/2017
I added Screw Holes at the Bottom of the Case. These are for the Stand that now comes with this Package. Thanks to stage_monkey for the Idea. If you want a Raspberry Pi 3 instead of Mosfets, check out his remix https://www.thingiverse.com/thing:2516091
Update 09/03/2017
Case got a much needed Update due to a Design flaw.
The Holes for the Cables are not bridged anymore, so you don´t have to cut them.
Now it´s just print and use.
If you run in to any Problems, Please let me know.