Tamiya ORV Rear Suspension Pivot Cover/Retainers by C0mfortCruise

Last crawled date: 2 years, 10 months ago

As is per-usual with these older ORV models, my original rear suspension arm retainers had fallen apart just by being looked at wrong. And while there is a usable replacement already up by a user "Clariman" on Thingiverse, some of the part's walls are thin or un-supported, and have no pre-cut holes for screws.
So with that in mind, I decided to run off of the well-designed pivot he had already made, but with further reinforcement and screw holes.
Though I haven't yet had the chance to test them in-action, when printed with Petg at 100% infill they seem incredibly sturdy. And after using the original screws and pivot arms, there doesn't seem to be any clearance issues either. Only thing I may need to tweak later on could be differences in travel allowed when used with the modern MIP Ball Diff, as I did have to add a washer underneath the left side cover due to the dogbone axle overextending slightly. Either way, they seem like a worthy replacement when compared to their doomed original counterparts!
Happy Printing!