Strong Magnetic Hook by bcDesigns

Last crawled date: 3 years, 1 month ago

This model was built to snugly fit these dangerously strong magnets I had laying around. They are actually scary strong, I dont doubt these could break a finger if you're not careful just fyi.. But hey, let's use these to make a really strong hook for hanging anything on whatever ferromagnetic surface you can find!
Fridge hook for keys? you got it.
Railing hook for your balcony? probably.
Ceiling hook for hanging plants? We'll see
Laptop destroyer of worlds? Yeah, don't get these near your electronics. Seriously..
These hooks are awesome and super effective, In the picture above each coffee can is full of dirt and soaked (got a couple of sprouts starting out in each one - Jalapenos on the left and Habaneros on the right) and I still have to pull decently hard to release the magnets from the ceiling, so that's my factor of safety.. Maybe one day it will rain hot peppers and dirt on my balcony, but that's a risk i'm willing to take apparently.
Some Advice:
If the magnets don't fit in the slots, you can adjust the x/y scale of the print in your slicer OR just use some tape to keep them in the slots if you're not too worried about aesthetics.
I printed these with 30% infill, but you could probably go as low as 15-20% depending on your application