Stack On Replacement Drawers with Handles by Masterkookus

Last crawled date: 3 years ago

These drawers were designed to work with some of the Stack On 39 Drawer Storage Cabinet to provide divided drawers. I have tested the ones in included in this in my cabinet, but due to printer differences and manufacturing differences I don't know if they will work in all of them.
Currently I only have the smaller drawers completed, with two compartments or three. I intend on doing the larger drawers in the future, the basic drawer is designed just need to come up with how to divide them.
The handles come in two varieties, one for 6-32 hardware and one for M4 hardware
M4 bolt 8mm length or less with washer
M4 nut press fit into M4 knob
6-32 screw 3/8 inch length or less with washer
6-32 nut press fit into 632 knob
Just insert the bolt from the inside and screw the knob on.
9/3/2016: Added 4 compartment bin
9/8/2016: Added 4 compartment bin variation A: 1 large and 3 small compartments
9/18/2016:
Added small bins two and three compartment variations
Two compartment (horizontal division) large bin (untested)
Two compartment (vertical division) large bin (untested)
Three comartment large bin (untested)
Four compartment (equal divisions) large bin (untested)
Four compartment (one large division and three small divisions) large bin (untested)
Five compartment (two medium divisions and three small divisions) large bin (Tested 9/16/2016)
Five compartment (one large division and four small divisions) large bin (untested)
Six compartment (two medium divisions and four small divisions) large bin (untested)
M4 handle (Tested 9/16/2016)
6/32 Handle (untested)
10/9/2016
Fixed Error in 6 Compartment large bin, sketch was slightly off due to not being completely constrained
Added 8 compartment large bin
10/11/2016
Added a variant on the 6 compartment large bin