SpaceX BFR/Interplanetary Spaceship v2017 (with booster and landing legs) by Zastro

Last crawled date: 3 years ago

This is the Big Effing Spaceship as presented in 2017.
It come in 3 pieces: the top, bottom, and legs. Print without supports.
I apologize for the coordinate system being off; the models should be rotated to print from the bottom up, as shown in the thumbnail, except for the legs, which should be printed "upside down."
UPDATE 11/18/17:
I didn't like the proportions the first time. This is a whole new model, with a more accurate aspect ratio, smaller wings, and 3 atmo engines, all of which were requested. The top and bottom halves are also keyed so post-print assembly should be easier.
UPDATE 11/18/17:
Ok I finished tinkering. Just added some window and trimming detail, and moved the fore thruster assemblies forward to be more like the illustrations.
This version should be pretty close to the as presented illustration.
UPDATE 11/19/17:
Finally printed this and didn't like how tight the legs fit into the body, so I increased the clearance. Also uploaded retracted legs, and a 1-piece body for smaller prints.
The booster is now available as a 1-piece model. I will work on a 3-piece booster for making larger models later.
UPDATE 2/20/18:
Been getting a lot of comments about the nozzle extensions on the booster not printing properly, so I beefed the up to make them printable at smaller scales.