Sovol SV01 & SV03 Hemera Mounting plate by GreameGB

Last crawled date: 3 years, 1 month ago

This is a simple mounting plate for the Hemera extruder for the Sovol SV01 and SV03 with the BL touch
This prints flat The support is only for the 4 screw holes in the back that mount the Hemera. in Cura use the "Touching buildplate" option in support placement.
The Hemera is mounted and screwed on at the back see picture
The mounting plate is mounted on the X carriage using the original screws that held the old extruder on (you will need to split the extruder from the stepper motor to access the 2 bottom screws) put the extruder back together and fit the extruder fan
Mount the BL touch, the probe offsets are X -32 & Y -9 the Z offset is -1.0 (take care as yours may be different)
wire the Hemera into the main board on SV01 or the X gantry on the SV03
On the SV03 the the X home offset is -22
There are eyes to use for the cable ties on the mount
you will need a firmware update to use the Hemera fully
(the stepper motor direction needs to be reversed)
(Maxtemp needs to be 300)
(Temperature sensor needs to be set to 5)
(Stepper motor current needs to be set to 940)
(Filament sensor for some reason I had to set Filament sensor inverting to "true")