Sonicmodell Binary wing connector mount

Last crawled date: 4 years, 2 months ago

I designed this part to allow clean and fast wiring of the wing connections inside Sonicmodell's Binary. It offers recesses for a female XT30 and differently sized pin headers.
Installation:
Feed the cables through the slots from the bottom
Solder pin headers to the cables. Pay attention to make compact solder joints or the assembly might not fit
Press the pin headers in the recesses. It helps to use a empty servo connector. Make sure the pin headers are seated properly. The last portion of each recess (except of the XT30) is a little bit tighter, so it might require some force and/or minor cutting on the plastic part of the pin headers. While the fit is tight, I recommend to use a small portion of glue glue to secure them.
The 2/3/4 pin servo connectors should now fit tightly but are still removable without friction
Screw the assembly to the Binary's wooden FC mounting plate using two screws that normally come with servos. Some might prefer to glue it in place.
There are currently two versions of the design which offer the following features as indicated by the file designation:

Left/right variant with 2 motor controler pins, 3 servo pins and 4 LED pins:
L_XT30-2M-3S-4LED
R_XT30-2M-3S-4LED

Left/right variant with 3 motor controler pins (BEC), 3 servo pins and 4 LED pins:
L_XT30-3M-3S-4LED
R_XT30-3M-3S-4LED
I can upload further versions on request!