Solidoodle 3 e3d v6 bowden hot end mount by ease

Last crawled date: 3 years ago

v2 update :
X endstop surface extended so there should be no need to bend the end stop out.
went from glue in nuts to drop in nuts so there is no chance of them pulling out, allowing for a much more snug fit.
In cura, set support material for bed only and let the nut gaps bridge, worked fine for me.
e3d w/ bowden mount for solidoodle 3 (maybe 2?)
You'll need : two m4 15-40mm bolts, two m4 hex nuts to superglue into the mount. (changed to a drop in style in v2, no glue needed)
The two m4 bolts will allow for future accessory mounting.
Two m3 bolts to attach it to the stock carriage. I used the ones that were they and let them grab into the new part.
I had to gently bend my X end stop out a little to get it to trigger. (fixed in v2)
Printed at 40% infill .3 layer height
Printed with support for the end stop wall. Rotate the clamp 180 inside of the hot end interface is pointing up.