Smartphone holder as Wireless Charger without screws - for Table and Wall - can be expandet

Last crawled date: 4 years, 3 months ago

At first:
If you have some problems to fit the Wireless charger in the Cover, write to me and I will make a new version for it.
At the description of my Wireless charger it says:
coil: 45mm x 2mm high
circuit board: 48mm x 17mm x 3mm hight
You should not take that description too seriously.
About the Print:
The Rotation of the print is to prevent Support. I tried to prevent screws and made it flexible. If you have some ideas, you can make your own Feet or Hand.
Connections Feet:
2.8mm x 11.6 mm and 8mm deep (square)
The triangle on both sides are 2.8mm / 2 = 1.4mm hight
Connection Hand:
2.8mm x 10 mm and 8mm deep (square)
The triangle on both sides are 2.8mm / 2 = 1.4mm hight