Small Screwdriver Bit Organizer by christofbaumgartner

Last crawled date: 3 years ago

Small Screwdriver Bit Organizer
An organizer for small precision screwdriver bits (e.g. iFixit). I designed it to fit to my Proxxon/Dremel Bit Organizer.
Model Details
The organizer can fit 66 tool bits
Dimensions (length x width x height): 101mm x 107mm x 72mm (3.98in x 4.21in x 2.83in)
The holes are 5mm (0.19in) in diameter. Normally 4.5mm are enough, but I added some margin, to avoid any requirement of postprocessing the holes.
The holes are 16mm (0.63in) deep
the holes are shifted between the individual layers to make access easier.
The lower tray is 25mm (0.98in) deep.
Tips for printing
I originally had the lower half of the model hollow, but changed it after I sliced it and didn't found much improvement in print time compared to a version with low infill. As this model doesn't have high structural requirements, I made some changes to my default print profile.
Reduce to 3 bottom layers (It is only a flat surface)
Reduce to 5 Top layers (Adjust this in combination with temperature and infill. If you print hot and with less infill, you might need more to get a flat top, otherwise even 4 can work)
10% infill
Reduce to 2 Outer walls (if you don't mind ghosting)
A 0.6mm nozzle doesn't hurt the quality at all.
Other sets
Check out my proxxon bit holder to have a matching set: https://www.thingiverse.com/thing:4709002