Sluice Mats

...another sluce mat thingiverse this is a sluice mat for the bottom of a sluice box for gold panning.

...sluice riffle mat for gold prospecting by trippsy25 thingiverse a sluice mat a designed. as of yet it is untested.

...sluice mat for gold prospecting by trippsy25 thingiverse a sluice mat i designed. as of yet it is untested.

...sluice mat for gold prospecting by trippsy25 thingiverse a sluice mat i designed. as of yet it is untested.

...sluice riffle mat for gold prospecting by trippsy25 thingiverse a sluice mat i designed. as of yet it is untested.

...sluice riffle mat for gold prospecting by trippsy25 thingiverse a sluice mat i designed. as of yet it is untested.

...gold sluicing mat by lavenderguy thingiverse 5" x 5" blocks x 4 gold sluicing mat.

... boarder to cast silicone mats. you can can stretch to fit you sluice box. the longer you stretch the bigger the riffles will be.

...vortex gold sluice mat by nimmermehr thingiverse

...vortex sluicebox mat shark by nimmermehr thingiverse vortex mat for a 10 inch sluice.

...shallow sluice and the deep sluice for transitioning between them. crappy job done in meshmixer, but it'll get the job done.

...pocket sluice by mikecook1966 thingiverse folding mini pocket sluice use support on bottom !!!!!!!

...sponge or soap sluice by technutty thingiverse sponge or soap sluice

...sluice box by bmxhippo thingiverse a sluice box made for home fun you put the lid on and you put dirt on top and run water threw

... to the sluice (part1) to keep the gold, and water running straight down your box. available at shapeways: http://shpws.me/r7w4

...mini sluice box keychain by goldminer thingiverse mini sluice box keychain

...gold sluicing mat by lavenderguy thingiverse 5" x 5" blocks x 4 gold sluicing mat.

...fluid bed sluice box thingiverse this is a 24" single chamber fluid bed sluice design that i created from scratch.

...sluice mat for gold prospecting by trippsy25 thingiverse a sluice mat i designed. as of yet it is untested.

...mat by tk2567 thingiverse i didn't find any dowsing mats for pendulums on here so i figured i would...

...mat thingiverse i made a lot of mats and mats i've seen so many times before. i hope everyone...

...beer mat by konstruktor thingiverse beer mat

...motor mat by allen0106 thingiverse just is a mat

...another sluce mat thingiverse this is a sluice mat for the bottom of a sluice box for gold panning.

...a trivet or a mat by gregoware thingiverse a trivet (or a mat) ...for cold thing if you print in abs or pla ;-)

...volvo s60 floor mat clip, mat retainer by hawaij thingiverse

...f custom logan blades. i also made it a little larger and easier to grip. it cuts a 52 deg. beveled edge in standard mat board.

...mold if you want to make your own silicone mats ...