Slot Car Track Wall/Barrier Bracket

Last crawled date: 4 years, 3 months ago

This remix (of my other bracket) is designed to use 1 1/8" x 1/8" Lattice Moulding instead of the Vinyl Screen Tight. I find the Lattice Moulding to be less rigid - so it easily conforms to turns without issue. However, it will not conform to the high-banked turns. I also intentionally made this bracket wide so I could use it to hold two pieces of lattice end-to-end. I will be posting another remix of this bracket that is very skinny, use less media and cut down on print time.
Like the Vinyl, the lattice is also available at most Lowe's stores, and approx $4 per 8ft piece. It will clip under the edge of the Carrera 1/24 track at any location except on some areas of lane changer pieces (where the bottom is enclosed).
Here's a link to the lattice I used:https://www.lowes.com/pd/Inteplast-Group-Building-Products-Common-1-8-in-x-1-1-8-in-x-8-ft-Actual-0-125-in-x-1-125-in-x-8-ft-Crystal-White-Polystyrene-Traditional-Lattice-Moulding/50148000
Note: You will need to slide the bracket onto the lattice from the end - it's not intended to clip midway.