SK-Go optical endstop sensor mount by superhans

Last crawled date: 3 years, 1 month ago

Goals for this mount:
works in Y-rails position B (rear position)
easy to print
easy to mount
minimum material use
Mounts in the Y max position (the screw is used to keep the endstop mount in place)
IMPORTANT: The homing sequence has to change from XYZ to YXZ and the homing direction of Y.
How this can be achieved and how the Y axis offset can be dealt with (temporarily extend the range of the axis), is described and the config I use is hosted here:
Homing config: https://github.com/sprhns/rrf-homing
Printed parts required:
1 x sensors_mount
1 x Y_trigger
1 x X_trigger_standalone or X_trigger_piggy_back (when the backplate is occupied with: https://www.thingiverse.com/thing:4700426)
Additional non-printable parts required:
1 x M3 x 14 mm screw or 1 x M3 x 16 mm screw with 2 x M3 0.9 washers (optional - only cosmetic)
3 x M3 x 10 mm screws
4 x M3 nuts
2 x Lerdge optical endstops