Servo Shim by Finntrollet

...ther output for your second rear axle. this uses three traxxas pinions 14t 32p (part# 5640) and six 5x11x4 bearings (part# 5116).

...ar bumper by finntrollet thingiverse could not find a rear bumper that fitted my f-100 body, so just learn how to make your own.

...bumper gmade sawback by finntrollet thingiverse my friend wanted a rear bumper for his sawback, so we designed this one for him.

...nd wanted to plug his view/peek hole in the door, made this for him. the plug is 13mm to 10mm-ish. two diffrent handles in this.

...ttle adapter to fitt on the motor axle (5mm) and inside the propeller (6mm) and gave it 3mm spacing to the motor. fits very good.

...unt his steering servo in the chassi of his gmade sawback. so after som thinkng and testing, we got this simple mount to install.

...ade an 11mm shim for the rockslider, so the slider lays flush against the body i´v got. 12/1-19: a 17mm version also in here now.

...ocktower for the hg p601 6x6 1:10 rc crawler. no bodypost holes, we use neodymmagnet insted, just glue inte on the smal platform.

.... just make a mirror of this one, and you got both left and right. 1 3mm led for position light. 2 5mm led for low and high beam.

...tree shim thingiverse i used this to shim my christmas tree because the trunk was too narrow for the stand.

...shims - metric thingiverse i made a set of 50x15mm metric shims, in the sizes 0,5-1-2-3-5mm.

...door shim by ggglitch thingiverse a shim for a door hinge.

...shim for a pram by bscheshir thingiverse front-mount shim for hapich aviator

...crankbrothers cleat shim thingiverse a shim for crankbrothers cleats. 1 mm thick

...closet door shim thingiverse door shim for my dads closet doors.

...simple shimming bracket thingiverse these are a sample shimming backet in order to mount the table with the exacted height

... used. shove these under the toilet or whatever with the legs down, then cut it flush. worked great for me, no need to buy shims.

...ed this to shim the wheel hub bearings and suspension arm. 6x11,5x0.2 16x12x0.2 use your slicer to adjust the thicknes if needed.

...bl touch shim by shootquinn thingiverse 0.2mm shim for your bl touch.

...servo to servo by mrbancroft thingiverse servo-to-servo connector

...servo to servo idle by hackens thingiverse plug a servo to another servo

...thingiverse this is a small servo retainer for 9g servos. the little ones that come with servos are terrible. i used a 80% fill.

... spycatcher2k thingiverse servo mount for proto-pic servo , part number ppservo1 : http://proto-pic.co.uk/analogue-9-gram-servo/

...aero servo mount 9g servo thingiverse aero cover for a 9g servo

... servo case for a olimex servo. specifically the ms- 1.3-9. just a protective case for the outside of the servo. print at 50mm/s.

...servo mg996 thingiverse servo mg996

...servo lock thingiverse servo lock

...vo mount (micro servo) by condac thingiverse servo mount for micro servo to use cable tie to mount a micro servo where you want.

...r structure. this allows the servo to be removed so you can change the servo arm without gluing/regluing or mangling you vehicle.