SD9VE/SIGMA Magazine +6/7 Round Extension by AEGIS_DEFENCE_CORP 3d model
3dmdb logo
Thingiverse
SD9VE/SIGMA Magazine +6/7 Round Extension by AEGIS_DEFENCE_CORP

SD9VE/SIGMA Magazine +6/7 Round Extension by AEGIS_DEFENCE_CORP

by Thingiverse
Last crawled date: 3 years, 2 months ago
AEGIS DEFENCE CORP.
MODEL: SD9-VE/SIGMA 9MM
PART: CM-9-01-0A.1002
+6/7 Round Extension for standard issue SD9VE Magazine
REQUIRES:
x2 M3 - 4mm Cap Screws to secure extension to magazine
(Length of threaded section SHALL NOT EXCEED 4mm)
Minor "Stretching" of the stock spring (by 2mm) in three locations;
Top, Middle, Bottom spans
*PROTOTYPE (Design subject to change)
*Consult local laws regarding Magazine Capacity BEFORE attempting to produce
ADC and its constituents are not responsible for any damages, legal infractions or misuse.
AEGIS DEFENCE CORP.™
"Defending the Future.."™
UPDATE: MK1 v2
Increased overall internal diameter by 20mm
Reinforced Baseplate Interface lip
Reduced size of locking tab
added front reinforcement
added lower shell integrity reinforcements
added rear lower-to-upper reinforcement
UPDATE MK1 v3:
Removed Locking Tab (Interfered with lower)
Added two 1.3mm "Locking" guides in baseplate-interface
Added two reinforcements along each side to reduce sheering
UPDATE MK1 v4:
Reduced front of model by 1.2mm
Reduced density of front bevel
Removed front reinforcement
Inverted Locking guides
Removed Ledge on inner-diameter of model
Added Easter-Egg
UPDATE MK1 V5:
REMOVED Locking Guides
Increased inner diameter to prevent follower from catching
Increased lower reinforcement bands
Added two bores for M3 - 6mm Bolts
STATUS: PROTOTYPING/TESTING PHASE: COMPLETE
RELEASE ETA: RELEASED
MODEL HAS BEEN DEEMED FUNCTIONAL as of 13/3/2021

Tags