SD-Card storage (12 cards) by olidub

Last crawled date: 3 years ago

This is a round SD-Card holder. If you turn the bottom, one after the other SD will be lifted, so you can grab it easily.
Turn the rotor counter clock wise, the cards will lift.
Turn the rotor clockwise, the rotor locks to ensure that all cards are fully recessed to close the lid.
Dont turn to fast!! Or you will see flying SD-Cards.
You need an M6 x 35 mm screw, an M6 lock nut and a M6 washer.
Tighten the screw very softly. Keep an eye on the gap between stator and rotor.
The lid is made of PETG. Rotor and stator are PLA.
The key is just to hold the nut while thightening. (Space between nut and housing is too small for a socket wrench. But you can use a plier)
26.2.2018 Added stackable lid. Use 3 self-adhesive rubber feet. (Something like 3M Bumpon 6mm)
Take a look at the new version for 25 SD-Cards: https://www.thingiverse.com/thing:2815132