Schoolstuff by mechadense

Last crawled date: 3 years, 1 month ago

This is an entry for the #backtoschool Challenge
Objectives:
good functionality
no sharp edges
sufficient sturdiness
use of a moderate amount of material
acceptably nice look
Ruler:
Since compared to 2D printers 3D printers have limited resolution it is intened to print the scale on paper or transparent foil and glue it onto the rulers edge with scotch tape. I've included a ruler vectorgraphic file (easily editable with inkscape). The rounded ends of the ruler are slightly elevated. They protude over the rulers thickness in the center area. Those protrusions are there to prevent the scotch tape from getting ripped off accidentally.
Pencil Topper:
I suggest printing the pencil topper with three color-layers e.g. red black green so that the eyes and mouth stay black. Stick it onto your pencil and signal yes or no; good mood or bad mood when putting up your hand.
Pencil Case:
Print it like a vase. Set the Wallthickness to 1mm.
If you want a different wallthickness you must recompile the *.scad file with a different t paraneter.
All files should be customizer ready, but they are in different *.scad files so I can't activate customizer here.