Safety Razor Travel Case by PDZ

Last crawled date: 3 years ago

This is a travel case for the Feather Model AS-D2 safety razor, a 5-pack of blades, and a small pair of tweezers. It can be readily adapted to razors of other sizes. The print is in three parts: the case top and bottom and the latch. I used cut-down brass escutcheon pins for the hinge pins, but any appropriate diameter wire will do.
I put in the hinge pins, then sanded the case exterior while it was closed. Of course, you don't have to sand it if you prefer. The case was printed in colorFabb nGen and the latch was printed in Taulman PCTPE. The latch was clamped in place and glued with Cyberbond 2002, a wicking-type cyanoacrylate:
http://www.audiologysupplies.com/ecom/productpage/a6af12b8-95d5-41ff-b64c-8e5eaa31c8ca?category=daeb57df-9915-478d-ac89-d8cd731951b7