Räsvelg Canopy by falconmultirotors

Last crawled date: 3 years ago

The canopy from the Räsvelg 3" and 5" race quads. This canopy has a built-in 7mm spacer and is designed to bolt to a 2-layer 30.5mm stack, and is designed specifically to hold HS1177-style cameras without mounting hardware.
Supported FPV cameras:
HS1177 / Foxeer XAT600M
RunCam Swift V1
This canopy does not fit the Foxeer Arrow, RunCam Swift 2, or RunCam Eagle as they lack the nubs requires to snap into the canopy.
Installing the camera by drilling screws through the side of the canopy will compromise the ability of the canopy to absorb impact and will likely result in broken canopies and cameras. Do it at your own risk.
Supported lenses
The canopy is designed for 14mm outer diameter lenses, with camera nub holes for 1.8mm and 2.8mm focal length lenses. Some 2.5mm lenses may fit, but only if they have an outer diameter of 14mm.
Required hardware
Depending on the thickness of the frame, you'll need some fairly long M3 screws. The 3.5mm Räsvelg 3 uses 25mm screws in the front and 30mm in the back, so you can count on requiring 22mm + plate thickness in the front, and 27mm + plate thickness in the rear.
Finally, you'll need 4 M3 locknuts and 4 5mm M3 standoffs, and perhaps some o-rings to space things out and provide a little damping.
Where to buy
Räsvelg kits are available at http://falconmultirotors.com/rasvelg.html
Professionally printed canopies are available from Phoenix 3D solutions:
Nylon: https://www.phx-3d.com/product-page/r%C3%A4svelg-nylon-canopy
TPU: https://www.phx-3d.com/product-page/r%C3%A4svelg-tpu-canopy
License
Like the sidebar says, Garuda Race Canopy is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
Please refer to https://creativecommons.org/licenses/by-nc-sa/3.0/us/ for the full details. We're not lawyers, but here are some guidelines:

NonCommercial —You can't sell printed canopies or make profit when printing for others as a favor. Don't put it up on your website and offer it for sale.


Attribution — You need to credit Falcon Multirotors when sharing your remixes. Please upload your remixes to Thingiverse with a title that makes it clear what you changed, and cite this thing under the Remixes section so others can find your awesome modifications (which covers credit and linking to the license). We also appreciate it if you link to http://falconmultirotors.com as well!

ShareAlike — This means you need distribute your remixes under the same license.