Rumba Case with optional Display Stand by The_NESt

Last crawled date: 3 years, 1 month ago

This case is for the Rumba 3D printer card and optional also for the RepRapDiscount Display
The display stand is designed so it can be turned around and the display can as well be mounted one way or the other.
BOM Case:
1 x Bottom Case
1 x Top Case
1 x 80mm fan
1 x 80mm fan guard Thanks to freemark for this fine fan guard design
4 x M3*6mm bolt for Rumba board mount
4 x M3*40mm bolt for Case assembly
4 x M3*40mm bolt for Fan 35mm is better if possible (3x30mm can be used if no fan guard is used)
8 x M3 Nut
BOM Display:
1 x Display Stand
1 x Display Lid Thanks to e-nozzel for this fine case design
1 x Knop Thanks to e-nozzel for this fine case design
1 x Knop Big Thanks to e-nozzel for this fine case design
4 x M3*10mm bolt for display stand
4 x M3*10mm bolt for RepRapDiscount Display
4 x M3*20mm bolt for display lid
4 x M3 Nut
I have glued in nuts in the top case so they do not fall out of the holes. If your 3D printer makes the hols too small you can insert them with a soldering iron with a round tip, I have found that useful in som cases
I have no brackets for it yet as I have desingen this case to be used for my build of the HyperCube Evolution and i just ordered the frame from china :)