Rubber Band Deagle (Desert Eagle) (3D Printable) by KingSam1st

Last crawled date: 3 years ago

3D Printable Rubber Band Deagle
I mean... Idk but u may be able to CNC it aswell.
UNTESTED
NOTE: Fusion360 Crashed Before I saved it to cloud so now changes will be harder without source
All but one of my pieces had severe layer shifting so excuse the photo's ugliness when I post
But look at the photos. It SHOULD work in theory.
It is printing now but it takes 24 hours to print all pieces but shorter if not together.
No Screws needed. All you need is a 3D Printer and glue. Glue each side together. (Not the moving parts) Slot in the dowels. Load a band on the back, and shoot!
I made this cos my old rubber band gun broke and I wanted to make something :D
Sadly the back bits need supports so place all bits with half facing down (Like in image(But with diff sides ofc))
On Ender 3 U can print all but 1 piece at the same time
IT IS 2 DIFFERENT PARTS COS MY FRIEND WANTED EACH SIDE A DIFFERENT COLOUR SORRY FOR ANY INCONVENIENCE
If tolerances are too tight then dip the dowels into boiling water for a few seconds (WITH TONGS!!) and then press them in.